Quick Set UV Resin is a one-component UV glue, also known as shadowless glue.

The performance characteristics are: strong adhesion and fast positioning.High transparency, high strength, low odour, high adhesion, aging resistances, fast curing and other advantages.

Quick Set is widely used for glass products, crystal crafts, transparent plastic, shallow silicone moulds, bonding applications and more.

Product features:

Brand:Bengatouch

Name:Quick Set UV Resin (1121S3)

Substrate:Acrylic

Viscosity:3900mpas

Tensile strength:>=20mpa

Hardness after curing:82D

Curing time:

UV-LED (6W-9W): 60~90 seconds per side

UV-LED (36W): 40~55 seconds per side

UV-LED (48W): 30~45 seconds per side

UV-LED (72W): 20~35 seconds per side

(Note: The better the light transmission of the material, and the stronger the UV curing equipment, the faster the curing time will be).

Reasons for choosing Quick Set UV Resin:

Practical spout bottle design – remove the protective foil and screw on the spout cap.The bottle is easy to operate and clean, and the resin is ready for use.

As this is a single part resin, no measuring and mixing is required.

UV resin, unlike a two part resin, will not start curing until light is applied.

Please note:

When storing, Quick Set UV Resin needs to be sealed and stored in a cool, preferably dark place.Keep out of reach of children and pets.

Before use, try a small amount to master the skills and techniques to avoid errors.

The bonding surface must be kept clean, dry, free of water, dirt, oil stains, rust, etc.

The resin has a slight odour before it is cured.

It is recommended to wear a mask and gloves while using the resin.

Pay attention to ventilation.The odour will dissipate in a ventilated environment after the glue is cured.

Tips:

A suggestion is to first try out a transparent craft to test.If adding pigment or dye, please ensure that they are specifically for use with UV Resin.

If your product is sticky after curing, repeat the light application on one side, and then turn it over to apply light to the other side.

Adjust curing times according to thickness and size of the jewellery or craft.

If it is too thick or too big, you many need repeat the light application.

It the product is not curing enough, or has over cured, and it has turned yellow, put the product in the direct sunlight, and it will turn crystal clear day by day.